LSD stable solution

Disclaimer: This guide is provided for informational and educational purposes only. We do not encourage you to break the law and cannot claim any responsibility for your actions.

This tutorial is focusing on how to prepare dosages that can be stored, for substances that are typically dosed below 10 mg (e.g. lysergamides (e.g. LSD), bromo-DragonFLY, fentanyl, etc.) since it's not possible to weight them on typical milligram scales.

Materials

• Personal protective equipment:
  • Face mask.
  • Protective glasses.
  • Disposable gloves.
• Isopropyl alcohol (IPA), preferably minimum 99.9% to avoid impurities that potentially will contaminate the column and reduce the lifetime. Rectified spirit can be used, but it is often easier to find IPA in most countries.
• Two sealed containers.
• 1 mL pipette.
• 1 mL vials. Filled vials prevent oxidation from dead space that will form in a larger container when it starts to be used.
• Sugar cubes.

Avoid

Water in any form:

• Avoid distilled water, it will break down the substance gradually and most of it will be degraded after about a year.
• Avoid tap water, because monochloramine is sometimes used. It's a very stable compound, and there are no guarantees that it will break down through boiling.

Procedures

Put on your protective gear.

IPA solution

• Add 1 g IPA per common dose of the substance, for example 100 mcg LSD. Stir the IPA until the substance has dissolved in it fully.
• Fill the vials.

Blotter to IPA solution

• For blotters:
  • Weight up the blotters.
  • To get out 90%:
    • Weight 0.5 g IPA per common dose of the substance, for example 100 mcg LSD.
    • Mix the blotters and the IPA in container A.
    • Move the blotters to Container B, close container A.
  • To get out the remaining 10%:
    • Weight 0.5 g IPA per common dose of the substance, for example 100 mcg LSD.
    • Mix the blotters and the IPA in container B. 1 g IPA solution should now contain a common dose of the substance of your choice.
• Transfer the solution from container A to container B. Seal container A and shake it.
• Fill the vials.

Labeling

To avoid overdoses, label the vials with the substance, and the strength.

Storage

• Store the IPA solution in a freezer, it will stay in its liquid state, and it will make it much more difficult for the IPA to evaporate from the container.

Usage

It is safe to consume a few milliliters IPA. However, it tastes unpleasant and can be avoided by evaporating it. Here's a convenient way to quickly do that:

• Drop 1 mL IPA per sugar cube.
• Let the IPA evaporate from the sugar cube(s) for 1 hour.
• Consume the sugar cube(s).