This is an unofficial archive of PsychonautWiki as of 2025-08-11T15:14:44Z. Content on this page may be outdated, incomplete, or inaccurate. Please refer to the original page for the most up-to-date information.
Vaporizing material with aluminium foil: Difference between revisions
Jump to navigation
Jump to search
>Oskykins Created page with "#Cut a 4:3 rectangle of foil. #Score in half horizontally. #Bend sheet into a U shape. #Line up an arbitrary volume at one end rather than forming a pile, so it heats evenly...." |
>David Hedlund m m |
||
| (4 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
{{stub}} | |||
#Cut a 4:3 rectangle of foil. | #Cut a 4:3 rectangle of foil. | ||
#Score in half horizontally. | #Score in half horizontally. | ||
| Line 7: | Line 8: | ||
Also, it is a good idea to burn both sides of the foil before use in case they are covered with any residue during production | Also, it is a good idea to burn both sides of the foil before use in case they are covered with any residue during production | ||
[[Category:Preparation]] | |||
Latest revision as of 02:39, 30 November 2022
 |
This article is a stub. As such, it may contain incomplete or wrong information. You can help by expanding it. |
- Cut a 4:3 rectangle of foil.
- Score in half horizontally.
- Bend sheet into a U shape.
- Line up an arbitrary volume at one end rather than forming a pile, so it heats evenly.
- Place the lighter on a low setting and stick a fairly wide straw in your mouth. In this instance, I wrapped foil around a scalpel handle (about an inch in diameter) then taped it into a cylinder. Keep the flame and tube in the same position while moving the foil at a 45 degree angle as the material melts and vaporises.
- keep the tube close to the trailing end of the material as to avoid losing the vapour
Also, it is a good idea to burn both sides of the foil before use in case they are covered with any residue during production